Bjm-pumps JX SERIES SIDE DISCHARGE Electric Submersible Pump User Manual

Version 2/3/2014 INSTALLATION, OPERATION & MAINTENANCE MANUAL J & JX SERIES SIDE DISCHARGE Electric Submersible Pumps Single Phase 115 &a

10 PUMP OPERATION This pump is designed to handle dirty water that contains some solids. It is not designed to pump volatile or flammable li

11 Single phase pumps always use a three-prong grounded receptacle. It is recommended that a Ground Fault Interrupter (GFI) type receptacle (or

12 STOPPING To stop the pump (manual and automatic mode), unplug it from the power source, turn off the breaker, or turn the power source

13 SINGLE PHASE WIRING INSTRUCTIONS FOR YOUR PROTECTION, ALWAYS DISCONNECT PUMP FROM ITS POWER SOURCE BEFORE HANDLING. Single phase pumps are s

14 “Risk of electrical shock” Do not remove power supply cord and strain relief or connect conduit directly to the pump. Installation and che

5 UUWarning: Pump will restart automatically when motor over-heat protection switch cools. PUMP RUNS BUT DOES NOT DELIVER RATED CAPACITY 1. Disc

5 8) Remove the inspection screw for the oil chamber (pos#50-08). Pour out a small sample of the oil. If it is milky white, or contains water, th

15 EXPLODED VIEW OF J400, JX400SS

16 EXPLODED VIEW OF J750, J1500, J1500H

17 EXPLODED VIEW OF J08, J15, J15H

18 EXPLODED VIEW OF J22, J22H, J37, J37H,

19 EXPLODED VIEW OF J55C, JX55CSS, J55CH, JX55CHSS, J75C, JX75CSS, J75CH, JX75CHSS

20 EXPLODED VIEW OF JX750SS, JX1500SS, JX1500HSS (PRECISION CAST MODELS)

21 EXPLODED VIEW OF JX08SS, JX15SS, JX15HSS (PRECISION CAST MODELS)

22 EXPLODED VIEW OF JX22SS, JX37SS (PRECISION CAST MODELS)

23 J SERIES PARTS LIST Pump Model J150 J400 J750 J1500 J1500H J08 J15 J15H J22 J22H J37 J37H J55C J55CH J75C J75CHPos. No. Part Description

24 24 Capacitor 115V 202414 202415 202417 - - - - - - - - - - - - -24 Capacitor 230V - 202416 202418 202420 202420 - - - - - - - - - - -26 Pump Top

25 JX PRECISION CAST PARTS LIST Pump Model JX400SS JX750SS JX1500SS JX1500HSS JX08SS JX15SS JX15HSS JX22SS JX22HSS JX37SS JX37HSS JX55CSS JX55CHSS

26 24 Capacitor 230V 202416 202418 202420 202420 - - - - - - - - - - -26 Pump Top Cover 203121 202434 202434 202434 202436 202436 202436 202438 2024

27 SINGLE PHASE WIRING DIAGRAM 115V & 230V W/O GOVERNOR SWITCH MODELS J400, JX400SS

TABLE OF CONTENTS INTRODUCTION ...

28 MODELS J750, JX750, J1500, JX1500H, JX1500HSS

29 THREE PHASE WIRING DIAGRAM 208V MODELS J08, JX08SS, J15, JX15SS, J15H, JX15HSS, J22, JX22SS, J22H, JX22HSS, J37. JX37SS, J37H, J37HSS, J55C, J55

30 230V MODELS J08, JX08SS, J15, JX15SS, J15H, JX15HSS, J22, JX22SS, J22H, JX22HSS, J37. JX37SS, J37H, J37HSS, J55C, J55CSS, J55CH, J55CHSS, J75C

31 460V MODELS J08, JX08SS, J15, JX15SS, J15H, JX15HSS, J22, JX22SS, J22H, JX22HSS, J37, JX37SS, J37H,J37HSS, J55C, J55CSS, J55CH, J55CHSS, J75C, J

32 575V MODELS J08, JX08SS, J15, JX15SS, J15H, JX15HSS, J22, JX22SS, J22H, JX22HSS, J37. JX37SS, J37H, J37HSS, J55C, J55CSS, J55CH, J55CHSS, J75C,

33 SEAL MINDER®

34 Seal Minder™ is an optional accessory on the J & JX Series. (Not available on the J400 or JX400)

35 BJM PUMPS, LLC 123 Spencer Plain Road Old Saybrook, CT 06475, U.S.A. WARRANTY AND LIMITATION OF LIABILITY Unless otherwise expressly authorized

START-UP REPORT FORM START-UP REPORT FORM This form is designed to record the initial installation, and to serve as a guide for troubleshooting at a

START-UP REPORT FORM presence? Are guide rails exactly vertical? Yes No Is base elbow installed level? Yes No Liquid level controls: Model Is

4 INTRODUCTION This Installation, Operation and Maintenance manual provides important information on safety and the proper inspection, disassembl

START-UP REPORT FORM Voltage supply at panel line connection, pump on L1-L2 L2-L3 L3-L1 Amperage load connection, pump on L1 L2 L3 FINAL CHECK Is p

NOTES:

BJM Pumps & Seal Minder is a registered trademark of BJM Pumps, LLC Copyright © 2006-2013 BJM Pumps, LLC. All rights reserved.

5 SAFETY Pump installations are seldom identical. Each installation and application can vary due to many different factors. It is the owner

6 INSPECTION Review all safety information before servicing pump. The following are recommended installation practices/procedures for the pump.

7 Note: For EPDM seals propylene glycol is used in the seal chamber OIL FILL QUANTITY/TYPE Qty. oil in seal chamber Models U.S. fl. oz. C.C. Type

8 PUMP INSTALLATION J & JX Series pumps have been evaluated for use with water or water based solutions. Please contact the manufacturer for

9 PUMP ROTATION Two ways to check the correct pump rotation: 1. By looking at the impeller; the rotation of the impeller should be counter clock